Machining the studs

You are not logged in or registered. Please login or register to use the full functionality of this board...

Linear Mode

Machining the studs

Dean Patterson (texas2dean)
texas2dean

Posts: 20
Threads: 1
Joined: Aug 2012

#14

03-18-2014, 06:59 PM

The old wheels are BUD wheels the new wheels are not BUD. The new wheels use a smaller nut so you buy a stud and a nut and turn down the shoulder on the stud. cost stud and nut $20.00 turn stud $15.00 buy the stud and nut @ Truck Parts World Longview Tx. Scott Logsdon 903-757-4572 Then find someone to turn Stud. Call me if you need help Dean Patterson 903-235-8478

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Machining the studs - by Richard - 03-07-2014, 07:15 PM

RE: Machining the studs - by rheavn - 03-07-2014, 07:40 PM

RE: Machining the studs - by encantotom - 03-07-2014, 09:05 PM

RE: Machining the studs - by Richard - 03-08-2014, 05:03 AM

RE: Machining the studs - by qcj - 03-08-2014, 06:20 AM

RE: Machining the studs - by encantotom - 03-08-2014, 07:16 AM

RE: Machining the studs - by rheavn - 03-08-2014, 07:43 AM

RE: Machining the studs - by encantotom - 03-08-2014, 07:48 AM

RE: Machining the studs - by rheavn - 03-08-2014, 08:25 AM

RE: Machining the studs - by qcj - 03-08-2014, 08:45 AM

RE: Machining the studs - by Richard - 03-08-2014, 04:34 PM

RE: Machining the studs - by encantotom - 03-08-2014, 05:22 PM

RE: Machining the studs - by folivier - 03-08-2014, 07:59 PM

RE: Machining the studs - by Dean Patterson (texas2dean) - 03-18-2014, 06:59 PM

RE: Machining the studs - by encantotom - 03-18-2014, 08:12 PM

RE: Machining the studs - by rheavn - 03-19-2014, 05:45 AM

RE: Machining the studs - by folivier - 03-19-2014, 05:56 AM

View a Printable Version

Forum Jump:

Users browsing this thread: 1 Guest(s)