Machining the studs

You are not logged in or registered. Please login or register to use the full functionality of this board...

Linear Mode

Machining the studs

encantotom
Administrator

Posts: 5,751
Threads: 493
Joined: Jul 2012

#8

03-08-2014, 07:48 AM

i have them on mine, but as i have said didnt need to do anything to put them on. i was only out the cost of the wheels minus what i sold the old ones for.

the upside is ride and capacity, the downside is if you have one go out, no one keeps them in stock.

tom

2002 45'8" Newell Coach 608 Series 60 DDEC4/Allison World 6 Speed HD4000MH

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Machining the studs - by Richard - 03-07-2014, 07:15 PM

RE: Machining the studs - by rheavn - 03-07-2014, 07:40 PM

RE: Machining the studs - by encantotom - 03-07-2014, 09:05 PM

RE: Machining the studs - by Richard - 03-08-2014, 05:03 AM

RE: Machining the studs - by qcj - 03-08-2014, 06:20 AM

RE: Machining the studs - by encantotom - 03-08-2014, 07:16 AM

RE: Machining the studs - by rheavn - 03-08-2014, 07:43 AM

RE: Machining the studs - by encantotom - 03-08-2014, 07:48 AM

RE: Machining the studs - by rheavn - 03-08-2014, 08:25 AM

RE: Machining the studs - by qcj - 03-08-2014, 08:45 AM

RE: Machining the studs - by Richard - 03-08-2014, 04:34 PM

RE: Machining the studs - by encantotom - 03-08-2014, 05:22 PM

RE: Machining the studs - by folivier - 03-08-2014, 07:59 PM

RE: Machining the studs - by Dean Patterson (texas2dean) - 03-18-2014, 06:59 PM

RE: Machining the studs - by encantotom - 03-18-2014, 08:12 PM

RE: Machining the studs - by rheavn - 03-19-2014, 05:45 AM

RE: Machining the studs - by folivier - 03-19-2014, 05:56 AM

View a Printable Version

Forum Jump:

Users browsing this thread: 3 Guest(s)