Machining the studs

You are not logged in or registered. Please login or register to use the full functionality of this board...

Linear Mode

Machining the studs

qcj
Super Guru

Posts: 910
Threads: 66
Joined: Feb 2013

#5

03-08-2014, 06:20 AM

I mention to the owner of Herman Power Tire Co. here in Nacogdoches that when I need new front tires that I was going to have 365s installed, but I understood that I would have to have new studs and the price was about $3,000.00. He said it would be cheaper to have Alcoa make you the wheels to fit the studs you already have. Really can this be done? He said why not! So that is as far as I've got. Might be something to look into.

Chappell and Mary
2004 Foretravel 36 foot

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Machining the studs - by Richard - 03-07-2014, 07:15 PM

RE: Machining the studs - by rheavn - 03-07-2014, 07:40 PM

RE: Machining the studs - by encantotom - 03-07-2014, 09:05 PM

RE: Machining the studs - by Richard - 03-08-2014, 05:03 AM

RE: Machining the studs - by qcj - 03-08-2014, 06:20 AM

RE: Machining the studs - by encantotom - 03-08-2014, 07:16 AM

RE: Machining the studs - by rheavn - 03-08-2014, 07:43 AM

RE: Machining the studs - by encantotom - 03-08-2014, 07:48 AM

RE: Machining the studs - by rheavn - 03-08-2014, 08:25 AM

RE: Machining the studs - by qcj - 03-08-2014, 08:45 AM

RE: Machining the studs - by Richard - 03-08-2014, 04:34 PM

RE: Machining the studs - by encantotom - 03-08-2014, 05:22 PM

RE: Machining the studs - by folivier - 03-08-2014, 07:59 PM

RE: Machining the studs - by Dean Patterson (texas2dean) - 03-18-2014, 06:59 PM

RE: Machining the studs - by encantotom - 03-18-2014, 08:12 PM

RE: Machining the studs - by rheavn - 03-19-2014, 05:45 AM

RE: Machining the studs - by folivier - 03-19-2014, 05:56 AM

View a Printable Version

Forum Jump:

Users browsing this thread: 3 Guest(s)