Machining the studs

You are not logged in or registered. Please login or register to use the full functionality of this board...

Linear Mode

Machining the studs

rheavn
Guru Master

Posts: 2,348
Threads: 386
Joined: Jul 2012

#2

03-07-2014, 07:40 PM

The explanation I received lacked detail and none was offered. I never got an answer why new wheels with the same hole size and type couldn't be used. This would negate the need to do any machining. The wheels were available in 1998, why not now? Just haven't got that answer.

Steve Bare
1999 Newell 2 slide #531

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Machining the studs - by Richard - 03-07-2014, 07:15 PM

RE: Machining the studs - by rheavn - 03-07-2014, 07:40 PM

RE: Machining the studs - by encantotom - 03-07-2014, 09:05 PM

RE: Machining the studs - by Richard - 03-08-2014, 05:03 AM

RE: Machining the studs - by qcj - 03-08-2014, 06:20 AM

RE: Machining the studs - by encantotom - 03-08-2014, 07:16 AM

RE: Machining the studs - by rheavn - 03-08-2014, 07:43 AM

RE: Machining the studs - by encantotom - 03-08-2014, 07:48 AM

RE: Machining the studs - by rheavn - 03-08-2014, 08:25 AM

RE: Machining the studs - by qcj - 03-08-2014, 08:45 AM

RE: Machining the studs - by Richard - 03-08-2014, 04:34 PM

RE: Machining the studs - by encantotom - 03-08-2014, 05:22 PM

RE: Machining the studs - by folivier - 03-08-2014, 07:59 PM

RE: Machining the studs - by Dean Patterson (texas2dean) - 03-18-2014, 06:59 PM

RE: Machining the studs - by encantotom - 03-18-2014, 08:12 PM

RE: Machining the studs - by rheavn - 03-19-2014, 05:45 AM

RE: Machining the studs - by folivier - 03-19-2014, 05:56 AM

View a Printable Version

Forum Jump:

Users browsing this thread: 2 Guest(s)