02-12-2014, 05:28 PM
I'm a little confused here, could you guys teach me about the magnets and bushings? There are pin receptacles on the top of my slides and they could be removable but they appear to be metal so what method is used to remove them?
I was browsing and discovered there are drains from the pin receptacles to the bottom of the slide, so I pushed a 1/8" fish tape up and opened them up. The rear slide is still plugged. Any way you've found to open them up? I've tried air and filling the pin socket with water in an effort to soften the plug material.
I was browsing and discovered there are drains from the pin receptacles to the bottom of the slide, so I pushed a 1/8" fish tape up and opened them up. The rear slide is still plugged. Any way you've found to open them up? I've tried air and filling the pin socket with water in an effort to soften the plug material.
Gordon Jones
2000-45'-2slide-#567