[qcj]

No I did not put loctite on the nuts. On the left side the nuts were covered with grease and dirt and could only feel them with my hand. Not enough room to see them. Pretty tight in there. The nuts are on top. I noticed it first because one of the bolts was far enough down, about 1/8", so that it shined like a clean new bolt. The right side was cleaner, because no grease fitting above it. Still could not see nuts on top. I used a ratchet on top and open end wrench on bottom to hold to bolt head. I have them tight now and will check on them from time to time and if they come loose again I will put new bolts and nuts with a lock washer. Couldn't tell with my hand if there was lock washers or not. I guess I will get a mirror and have a look on the clean side. The stabilizer is also bolted to this plate,and its two bolts were tight. So there is a lot going on here.