[hypoxia]

Where does the Silverleaf get its signal to show House Power?  House power is good, everything 12 Volts works, it just is not showing on the Silverleaf display.  I assume it is one of those Silverleaf boxes with a phone type data cord that needs reseated.  I have turned the battery switch off & on, no joy.     

[CaptainGizmo]

Jim,

The reading, I'm almost certain, is taken from the Outbacks.  Have you checked your MATE panel?

Sounds like you've checked, but I'd start at the beginning with the INVERTER 1&2 breakers; not just the House switch.

Have you checked your Overhead SilverLeaf to see if that, too, reads 0?  That would be a key indicator if it was the system vs. just a connection.  If it was ONLY the Galley display, then I might pull that panel off and check the RVC/Can-bus connections on the back.  Yes, just a bunch of "phone type" cabling as you call it.  A lot of the connectors, however, are MOLEX...the VMS system overhead is fed by a 12-pin, for example.

Next, I'd reboot/start the SilverLeaf system. This can be done in the Advanced menu or, just KILL everything...Switch and Inverters.  BUT BE SURE TO DISCONNECT SHORE-POWER or else it'll just bypass through the inverters anyways.

Hope this helps you a bit.

[hypoxia]

It started working but then I turned the battery's off again & it didn't work again. I was testing the battery's and I need to replace the battery's so I'll just live with it for a while. Thanks for the suggestions, Steve.