[Richard]

Well………..you know the alarm sounds when the switch is activated. Just sayin.

[Jack Houpe]

Once again you are correct.

[WillieG]

I have #465 and my tag bushings are shot also was had the coach in and the service department told me the torque bar on the drive axle is bad I’m assuming that is also called a panhard bar?

[Jack Houpe]

Yes it is called a panhard bar. Not trying to be a saleman but I have new bushings and a new panhard bar if your interested, I bought enough bushings to replace the drive axle which where not bad and the panhard bar had already been replaced on our coach. You will not believe the difference in drivability.

[WillieG]

I read Richardson post on tag bushing replacement and his looks the same as my tag bushing set up. Do your think you panhard bar would be the same as what mine(#465) is or would I need to do more research on what drive axle I have?

[Latitude 28]

Wille,
Check these drawings from Ridewell out....

2277605D000 Drive suspension supplied from 1995 to 1999
2460003  Drive and Tag suspension supplied from 1999 to 2003
2467667E000  Drive and Tag suspension supplied in 1997


All three drawings are the same length.

Correction;  I previously stated is should be the same.....Yours is a 97 double check the part number

It may not so please double check!

2277605D000-D.pdf Size: 689.49 KB  Downloads: 18

2460003-G.pdf Size: 735.42 KB  Downloads: 15

2467667E000-0.pdf Size: 1 MB  Downloads: 28

[Jack Houpe]

Check your part numbers, I post a picture of what I have.

[WillieG]

The part number on all three blueprints for the Panhard bar. Where is the blue print calls it sway bar. All appear to be the same part number if I looked at those correctly

---

Check your part numbers, I post a picture of what I have.

If you could post a picture of those parts or put the parts numbers on here that would be great

[Richard]

Yeah, I don’t know why the drawing calls it out as a sway bar. But yes part 26 is the panhard bar.

It will come as three pieces. The two ends are cut to the correct length and welded into the center sleeve.

[WillieG]

Yeah, I don’t know why the drawing calls it out as a sway bar. But yes part 26 is the panhard bar.

It will come as three pieces. The two ends are cut to the correct length and welded into the center sleeve.

Who is source for the pan hard bar?  Does Ridewell stock and sell these?