04-10-2022, 07:08 AM
Electrical problems:
I installed a macerator on PS, wired direct to house battery with toggle switch by spider control panel. Works fine.
It all started with fixing air conditioner 1 (AC1).
tested found no power at the unit.
checked breaker had power out.
traced wire to relay box that wasn't working.
It is below the main panel and controls AC1 & AC3. turns the power on or off via a signal wire (don't know (yet) what signals it).
jumped the signal wire and relay worked. stays active till i unplug shore power.
during the trouble shooting I turned main power on and off several times.
The 120 volt compressor wouldn't come on.
Newell took me thru total coach power rest for the spyder wire. it worked.
ran the macerator Shortly after I run the macerator the aqua hot will turn itself on in diesel mode Sometimes the auto tank fill turns itself on When the aqua hot is running as above, pressing the button turns the light on but the unit goes off after a cool down
The lights on the spider panels for that function seem to be opposite.
I am looking for the sypder wire control box location. ANY HELP WOULD BE GREAT.
haven't run macerator for 2 days and it seems the auto fill (city water valve) is ok, still lights as above and aqua hot turns on each afternoon.
I am going to run the macerator from a remote battery box to see if the macerator is causing a signal problem in the DC.
I installed a macerator on PS, wired direct to house battery with toggle switch by spider control panel. Works fine.
It all started with fixing air conditioner 1 (AC1).
tested found no power at the unit.
checked breaker had power out.
traced wire to relay box that wasn't working.
It is below the main panel and controls AC1 & AC3. turns the power on or off via a signal wire (don't know (yet) what signals it).
jumped the signal wire and relay worked. stays active till i unplug shore power.
during the trouble shooting I turned main power on and off several times.
The 120 volt compressor wouldn't come on.
Newell took me thru total coach power rest for the spyder wire. it worked.
ran the macerator Shortly after I run the macerator the aqua hot will turn itself on in diesel mode Sometimes the auto tank fill turns itself on When the aqua hot is running as above, pressing the button turns the light on but the unit goes off after a cool down
The lights on the spider panels for that function seem to be opposite.
I am looking for the sypder wire control box location. ANY HELP WOULD BE GREAT.
haven't run macerator for 2 days and it seems the auto fill (city water valve) is ok, still lights as above and aqua hot turns on each afternoon.
I am going to run the macerator from a remote battery box to see if the macerator is causing a signal problem in the DC.
2006 Newell #760
Cat 625
ZF 12
