[Latitude 28]

Not my idea but a good one at that, thought i'd pass it along.....    

[Jack Houpe]

Heck yeah Steve, great idea! Did you fabricte that?

[Latitude 28]

Oh no....found it on an HDT FB page.  I am using an X-12 torque multiplier and a 3/8 in-lb torque wrench set to the proper value on the in-lb scale then the multiplier does the rest @ 12 times the value set on my torque wrench to achieve the proper ft-lb torque.  I can do that by myself, setting on my shop stool and not break too much of a sweat.

[Jack Houpe]

Brilliant

[[email protected]]

I have thought about getting one of these for a while now:
https://www.kentool.com/product/32610-wr...ort-stand/

Don’t think I can make one for $60 bucks:

https://www.tooldiscounter.com/product/k...S1EALw_wcB

[Latitude 28]

Nope no way to make one for $50 unless one has a corner of their shop dedicated to scrap cut-offs.

[arcticdude]

Someone on the forum previously posted a wood version they made. It was very well done, similar to the first one posted. Looked alot like a Christmas tree. I made a poor man’s version out of a scrap piece of 3/4” plywood. Functional, but not very attractive.