[Wanderman]

Since I do not have a dinette table, I am going to have one fabricated from the original material.

i see two basic shapes from Newell's of my era. Round end and flat end with rounded corners. Either way, can someone measure it and tell me it's width )seat to seat) and length (from the wall. Also..if possible height of top above the floor.

Also, if anyone knows what epoxy is used both to assemble the layers and to fill in the routed trim line groove, I would be grateful!

Thanks,

[rheavn]

My table is an oval
    28 3/8" wide
    38 1/4" long
    28 3/4" high
    3" from wall
Dinette seat back to seat back is 70 1/2"

[Wanderman]

Thanks Steve