[folivier]

Please bring the cap for me Chappell.

[rheavn]

Using heat to taper the polycarbonate tubing down to fit inside the 5/16 vinyl hose has failed. It appears I had to overheat it to form it. It started to seep after 24 hrs. An autopsy showed that the tubing broke under the clamp pressure. I'm looking at other options.

[lbrachfe]

OK, so what would be the problem using a piece of clear fuel line from the tank through the sight tube clamps ??? it won't melt or burst from such little pressure .......

[rheavn]

One of the options I am looking at. Get the line that is 1/2" od and it will fit in the existing clamps.

[folivier]

That's what I have on mine. Haven't measured the od but the id fits the fitting on the bottom of the tank and I have it looped over and run through the 2 clamps. There is no pressure on that line and it doesn't get hot.

[qcj]

Since the tank is plastic, I think it would have been a better design if they had put a clear 1/2" stripe in the tank itself. I know this not take care of matters at hand.

[lbrachfe]

Does anyone know where I can find just a top cap for the tube ?? I noticed today the top inch of the sight tube cracked off and the plastic vent cap with it. I put a dashboard x-mas tree holder w a Teflon tape inside as temp.
Don't want to buy the whole thing as mine is in fine shape, except the top one inch ....