Posts: 60
Threads: 24
Joined: Jun 2021
Sitting in Newton Iowa on our way to HWH. Hooked up to city water at the KOA and get very little flow from all the faucets and shower. The pressure at the city faucet is very good. Switched to the tank and pump, everything works fine. Checked the cold water filter and it is clean. Any ideas on where to start looking? Thanks.
Brandi and Chris
Coach #636
Hot Springs Village, AR
Posts: 1,130
Threads: 151
Joined: Sep 2021
There is a pressure regulator with a gauge. Some of them have a nut that is adjustable. I believe they are set to 35psi. If yours is low on pressure, either someone messed with it or the internals are going bad and you would have to replace it.
--Simon
1993 8v92TA #312
Posts: 1,531
Threads: 155
Joined: Jul 2012
On 653, if you turned on the “Auto Water Fill”, it would take all the pressure from the City Water and use that to fill the tank. After then tank is full, the pressure returned to normal.
Take a look at that switch in the galley / water bay.
Bill
Bill Johnson
Birmingham, Alabama
