Posts: 130
Threads: 20
Joined: Feb 2013
If I am going to lay a rubber coin floor over plywood floor in a trailer which adhesive would you all recommend to put down first? I'm thinking of doing a little trailer improvement this summer and I am a rank amateur when it comes to DIY...Your opinions and experience are greatly appreciated!
B
2003 Ford F250 SD
2001 Honda Civic
2005 Chrysler Crossfire Roadster LT
Posts: 232
Threads: 14
Joined: Jul 2012
Rubber tiles come in 18x18 inches. I use Roppe which is based in Fostoria, Ohio. On small areas, I use contact cement. You can do a large area and use a paint roller.
Ernie Ekberg
Bluebird Wanderlodge
Posts: 1,696
Threads: 123
Joined: Aug 2012
If the plywood is bare I'm wondering if you should put a coat of sealer or something on it before gluing the floor down. ????
1993 Newell (316) 45' 8V92,towing an Imperial open trailer or RnR custom built enclosed trailer. FMCA#232958 '67 Airstream Overlander 27' '67GTO,'76TransAm,'52Chevy panel, 2000 Corvette "Lingenfelter"modified, '23 Grand Cherokee.
Posts: 232
Threads: 14
Joined: Jul 2012
I did a job that the contractor put some sealer down. I did not know this. The adhesive was not compatible with the floor and material had bubbles all over the place.
Ernie Ekberg
Bluebird Wanderlodge
Posts: 1,696
Threads: 123
Joined: Aug 2012
That's good to know...Thanks for the reply , Ernie!
1993 Newell (316) 45' 8V92,towing an Imperial open trailer or RnR custom built enclosed trailer. FMCA#232958 '67 Airstream Overlander 27' '67GTO,'76TransAm,'52Chevy panel, 2000 Corvette "Lingenfelter"modified, '23 Grand Cherokee.
