You are not logged in or registered. Please login or register to use the full functionality of this board...


series 60 oil pressure sender?
#1

Anybody know where the oil pressure sender for the DDEC is located?
Just got a call from Mark, he's on the side of the road. His DDEC shutdown his engine on low oil pressure. His dash gauge shows pressure so he thinks it may be a sensor. But where is it?

Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
PO 1999 Foretravel 36'
1998 Newell 45' #486 

1993 Newell 39' #337 
Reply
#2

He's back on the road again. Sensor was bad, not sure if he got it replaced or was able to bypass it.

Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
PO 1999 Foretravel 36'
1998 Newell 45' #486 

1993 Newell 39' #337 
Reply
#3

i just got home so didnt see this. glad to know he got going again.

tom

2002 45'8" Newell Coach 608  Series 60 DDEC4/Allison World 6 Speed HD4000MH

Reply
#4

Replaced it.. Sitting at the broadmoor hotel in Colorado Springs, right now, thanksgiving buffet tomorrow and then head back home.. Thank you to everyone for their concern and help

Marc Newman
Formerly Newell 422, 507, 512 701


Reply
#5

Oh my, trashed a room at the broadmoor once worse than a rock band, only it was my first kidney stone. Good times!

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#6

Was the sensor located by the oil filter?

94 Newell #365, 2009 Smart, 2005 500SL, 2012 ML350, 1934 Ford Streetrod Golf Cart, 1958 Century Coronado, 1965 Cruisers Inc. Car and Boat CrazyTongue
Reply
#7

It was on passenger side near the front of the coach. Towards the top had to access it from the chassis battery door on the side

Marc Newman
Formerly Newell 422, 507, 512 701


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)