Help identifying a sensor? - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: General and or Other Stuff (https://newellgurus.com/forumdisplay.php?fid=16)
+--- Forum: General (https://newellgurus.com/forumdisplay.php?fid=21)
+--- Thread: Help identifying a sensor? (/showthread.php?tid=8222)

---

Help identifying a sensor? - Gem930 - 10-25-2024

Trying to clean up some issues in the wet bay of #639.  This sensor/sender looking thing is hanging above the city water regulator.  Anyone know what it is for?      

---

RE: Help identifying a sensor? - Jack Houpe - 10-26-2024

Its either a temp sensor or a door sensor so when you open the door the light will come on or could be a tank level sensor but its high so I bet its a magnetic door sensor. Turn on the light and put a wrench on its surface and see if the light goes out.

---

RE: Help identifying a sensor? - Richard - 10-26-2024

Hmmmm it could be the temp sensor for the wet bay. You may have a temp display over the microwave. Look at the inside temp. Put your hand on the sensor for a minute and see if the temp goes up

---

RE: Help identifying a sensor? - encantotom - 10-26-2024

i am with richard. i think it is the temp sensor for the wet bay

tom

---

RE: Help identifying a sensor? - Jack Houpe - 10-27-2024

I got a buck on it thats a door sensor . To high for Temp sensor they are mounted toward the bottom are they not?

---

RE: Help identifying a sensor? - Gem930 - 10-27-2024

Apparently, it’s not the door sensor as the door sensor is still working even with it hanging out there can’t really tell if it’s the temperature sensor because my temperature sensor always indicates LO. !!!

---

RE: Help identifying a sensor? - Richard - 10-27-2024

Do you have this readout?

   

---