slide seal cross section pictures - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Slides (https://newellgurus.com/forumdisplay.php?fid=55)
+--- Thread: slide seal cross section pictures (/showthread.php?tid=7891)

---

slide seal cross section pictures - encantotom - 03-15-2024

after we changed the slide seal on tim's coach i took a small section of the old seal and kept it.  i took these pictures so you can see how it has a piece that snaps into the track on the coach.  

tom

---

RE: slide seal cross section pictures - BusNit - 03-15-2024

Interesting! I do not have a slide coach but was curious what these seals looked like. For some reason I thought they were larger.

---

RE: slide seal cross section pictures - Jack Houpe - 03-16-2024

Good pictures Tom, when we bought the coach I found a complete seal minus the fill hose in one of the bays have thoughts on how to repair it.

---

RE: slide seal cross section pictures - Richard - 03-16-2024

Jack,

FWIW, 2 and half years ago, I had to replace the bedroom slide seal. Meaning I had some seal leftover. Just for grins I cut two small sections and butt spliced them using Loctite 495. I left it out in the Florida sun for over a year. I cannot pull it apart. I have flexed it, mounted it in a vice and pulled as hard as I can. The splice is holding strong.

My point being that getting a clean smooth bonding area and using Loctite 495 may be the answer you are seeking.

---

RE: slide seal cross section pictures - encantotom - 03-16-2024

as long as the salon seals are and how you need to smoosh them together.....if a section blew out or was cut, it would have enough room to cut it out and repair it and still have it fit.

if mine goes out again, i will give that a try. at 1200 plus a seal, worth a few bucks of locktite to try....ha

tom

---

RE: slide seal cross section pictures - Richard - 03-17-2024

I agree, if I ever blow one again, I will give patching in a good section a go. Both of my seals failed in the vertical runs that get the most UV exposure. The rest of the seal looked great.

There was a bit of a trick, I cut a small bit of sheet teflon to put inside so the Loctite did not stick together and keep the seal from inflating. I had some of that from an old grill sheet.

---

RE: slide seal cross section pictures - Jack Houpe - 03-17-2024

I will put this in my memory bank for the next time. Loctite 495

---