760 Valid leveler front solenoid location - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Air Operated Systems and Leaks (https://newellgurus.com/forumdisplay.php?fid=33)
+--- Thread: 760 Valid leveler front solenoid location (/showthread.php?tid=7425)

---

760 Valid leveler front solenoid location - [email protected] - 06-18-2023

I have an odd problem, the driver's side dropped when I hooked to shop air at 90 psi.
I upped the air to 110 and the coach leveled.
I can't find the front 6 pack solenoid. Any ideas?
I repaired a bad fitting on the rear 6 pack and think there may be a similar problem on the front one.

---

RE: 760 Valid leveler front solenoid location - kaptain - 09-11-2023

(06-18-2023, 04:50 PM)[email protected] Wrote:  I have an odd problem, the driver's side dropped when I hooked to shop air at 90 psi.
I upped the air to 110 and the coach leveled.
I can't find the front 6 pack solenoid. Any ideas?
I repaired a bad fitting on the rear 6 pack and think there may be a similar problem on the front one.

Did you find the answer?

On my coach 701, there is one 6-pack underneeth the driver seat. You have to look from the very bottom up to see it.
There is another 6 pack on the wall of the engine bay.
When the VALID leveling controller is set to "Travel" mode, 2 solenoid of each of the 6 pack feels pretty hot. 
Let me know if you find the same as above described.

---

RE: 760 Valid leveler front solenoid location - Richard - 09-12-2023

You may find that 90 psi is NOT enough to raise the rear. That is certainly true on the HWH slide coaches. A number of people have chased solenoid, HCV, and other issues only to discover this.

---