Underside things - Printable Version
+- Newell Gurus (https://newellgurus.com)
+-- Forum: General and or Other Stuff (https://newellgurus.com/forumdisplay.php?fid=16)
+--- Forum: General (https://newellgurus.com/forumdisplay.php?fid=21)
+--- Thread: Underside things (/showthread.php?tid=7171)
+- Newell Gurus (https://newellgurus.com)
+-- Forum: General and or Other Stuff (https://newellgurus.com/forumdisplay.php?fid=16)
+--- Forum: General (https://newellgurus.com/forumdisplay.php?fid=21)
+--- Thread: Underside things (/showthread.php?tid=7171)
Pages:
1
2
Underside things - BusNit - 01-13-2023
I have been working on removing 30 years of gunk from previous oil leaks that have finally been sealed up under my watch and expense. I am slowly working on making the underside clean and semi new again. My question is the service life of the brake chambers. I have type 30 brake chambers and they seem fairly cheap. Should I bother to replace them? I would do new hoses for good measure. My goals are to have the bottom side renewed to last another 30 years.
RE: Underside things - rheavn - 01-14-2023
I'd say that after 30 years changing both brake chambers & brake hoses are very important. Have already changed mine.
RE: Underside things - Jack Houpe - 01-14-2023
Dude that is beautiful, you did a great job! I work on 40+ year old Porsches and the first thing I do is replace the brakes and all the lines along with the fuel lines front and back, they are time bombs if you don't. Bingo Steve answered your question while I was typing.
RE: Underside things - CaptainGizmo - 01-14-2023
Man, Simon...that Pit is sooooo nice, huh!!
RE: Underside things - BusNit - 01-14-2023
Thanks Steve! I found the name of the service brake chamber but the tag axle has no identification. How would I go find these? Newell will not know based on my experience. I was going to buy the parts and have Leo install them. Found another air leak from moving hoses around along with a broken compressor bracket on engine. I think I could reach in there with my Mig torch. The more I dig around, the more seems to pop up!
RE: Underside things - folivier - 01-14-2023
In your second picture I'd be surprised if that push on tubing fitting doesn't start leaking soon with the bend where it is right near the fitting. Maybe you could either change the fitting to a compression or at least relieve the bend somewhat.
RE: Underside things - BusNit - 01-14-2023
That’s actually new work done by the trailer hitch shop when they added the air brake setup for the toad. They also used a white RO plumbing push on coupling on line. It is on my list of things to update.
RE: Underside things - BusNit - 01-21-2023
I just can't find what type of brake chamber is on the tag. Would they use a type 30 service to match the type 30-30 for the drive axle? I found a tag on the bolt of the tag chamber but no luck cross referencing on Google. BW B019113. Frustrating.
RE: Underside things - Richard - 01-22-2023
Oh my! You have a broken suspension bracket. That is going to take some serious welding to repair.
RE: Underside things - BusNit - 01-22-2023
That bracket is for the A/C compressor. I welded it up yesterday
Dash A/C doesn't work.