Ramco mirrors - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Documentation (https://newellgurus.com/forumdisplay.php?fid=13)
+--- Forum: Exterior (https://newellgurus.com/forumdisplay.php?fid=37)
+--- Thread: Ramco mirrors (/showthread.php?tid=2716)

---

Ramco mirrors - dannymarilyn - 01-26-2016

One of our 1991 mirrors had frozen set screws. If Kroil won't loosen it, don't twist so hard as to break an allen wrench off in the set screw!
Just simply drill the set screw out with a 1/4" bit, and then drill the hole with a 5/16" bit and retap the hole with a 3/8 x 16NC tap. Then remember to use
anti-seize on the new set screws. Ramco still sells the mirror bushings, but have upgraded them to aluminum from plastic.

On a newer coach, I'd suggest spraying with a penetrate, then remove and coat set screws with anti-seize before they become too corroded to
be adjusted.

Danny
1991 # 277

---

RE: Ramco mirrors - Tfrazier - 04-05-2021

New question to old post. I had the issue with the seized set screws so I followed the instructions and drilled the out. No problem.
I ordered the new metal bushings from Ramco but I can't figure out how to get the mirror head out of the socket to install the new bushings. Any advice?
Thanks Tony

---

RE: Ramco mirrors - DK on the road - 04-05-2021

Tony, I just replaced my passenger side mirror, for a different reason. Semi got too close going up a steep grade and I was passing. It broke off just above the ball.

Did you get all three screws out ? Use a pickle fork, or wedge. Spray lots of rust release product into the socket. It will come out, but your trying to avoid breaking the plastic mirror housing. The mirrors can be very expensive. Just kept moving the mirror in the socket, turn, roll side to side, and the ball on the mirror and the 2 sleeves should/will release.

Good luck !

---

RE: Ramco mirrors - Dystrakti0n - 10-18-2023

Do you guys happen to have the model number for these mirrors, my bushings are shot and I'd like to do a full replacement? Trying to figure out what my options are for that.

---

RE: Ramco mirrors - Tfrazier - 10-18-2023

(10-18-2023, 12:46 PM)Dystrakti0n Wrote:  Do you guys happen to have the model number for these mirrors, my bushings are shot and I'd like to do a full replacement? Trying to figure out what my options are for that.

Hi Marcus. Best thing to do is contact Ramco customer service. They are very knowledgeable and can help you figure out the correct part numbers. Good luck

---

RE: Ramco mirrors - 360 - 09-21-2024

Both of my top mirrors are loose and vibrate going down the road and while annoying what I’m more worried about is them coming loose from all is that movement over time

Are there bushings of some sort in there that need replaced? My smaller spot mirrors are still solid as a rock.

---

RE: Ramco mirrors - Richard - 09-21-2024

Hmmm, perhaps. I did have one of my top mirrors vibrate loose from its mounting plate underneath.
Tug gently and see if the mirror will release. If it does it may be as simple as reglueing them.

---